vikasbraj

Hi, Same Problem wat u r facing was faced by me in Redhat Linux 9. i m able to browse the computers in the network but not able to browse the internet, follow the steps wat i followed: 1. Activate u'r network card using "redhat-config-network" command and assign ip address and all its properties and save the changes u have made it. 2. Restart the service of network by using "service network restart" command. 3. Now open the web browser(for eg: Mozilla ) and go to Edit Menu and select "Preferences" and select "advanced" option and select "proxies" and select "socksv4" and select "manual configuration" and set the "full computer name" and click on "ok". 4. At this point i was abled to browse the internet, i hope u also got the result. All the Best.

Hello Sirs, I m using Redhat Linux 9 in my PC, and I have connected DLT 4000 Tape drive to my PC it has been recognised under /dev/st0. Now by using third party backup software(Netvault 7 from BakBone) i have taken a backup on to the tape in cpio format, backup has completed and now i want to restore the backed up file to my hard disk using cpio or tar command. iS IT Possible to restore using cpio or tar command? if it is possible, then pls give me the syntax of using it. i have tried using "cpio -itv < /dev/st0 ." it will show "read error: Input/Output error" at first time and again if i try the same command means it will display "Found end of the tape type device/filename and try again". can anybody have solution for this? pls help me... Thankful for the solution providers.. Thank U.