tophfro

Sweet, That did it. Thanks for the help. Btw What does the Force No APIC do?

Where could i get one of those cds?

Hi danleff, I ran through the setup before and tried it again accourding to the documentatin and I still get the same results. Are the cards just recognized or actually set up? Not Sure Did you set up the network connection during the installation? Yes Are you using a dynamic or static internet connection? Either, its part of a LAN. I have eth0 set up as a Static right now and eth1 dynamic. What onboard NIC is in the system? If you don't know, what motherboard are you using? MB = SOYO K7VME; It has the VIA KM400 Chipset When configured to Automatic: eth0.... [FAILED] eth1.... [FAILED] When I set eth0 to manual and assign the IP i get: eth0.... [OK] eth1.... [FAILED] Here is my network setup: Modem -> Router/Firewall - > Main Switch - > Second Switch -> Linux Box. I also Have a windows box sitting next to it and i am able to get on the net with it but not the linux. Any other info you need? Thanks

Hi, I just installed Mandrake 10.1 (PowerPack+) and everything seemed to go fine. I setup an internet connection and the control center says that my card is installed but when i try to connect It won't let them. I have 2 ethernet cards in the box (one PCI and on Built-in) and both have the same problem. Can someone help me? Thanks, Chris