z3rg

Maybe this helps you. I found if i uncheck in bios detect cdrom drives, cd drives work only in PIO4 BUT if the bios detect cdrom, DMA (UDMA) mode work ok. Abit KT7, Abit BH6 ... this worked for me

I have BF6 (thats the same as BE6-2 except UDMA66). Bus speeds 66,75,83,84-200 in 1MHz steps but i dont think u will help yourself so much buying this mobo. I can overclock my 400 celery max. to 86x6 (516). If i try higher FSB system isnt much stable and randomly restarts (Win2k, WinMe) ... but if u r gonna buy P3 thats a good choice

This firmware seems to be working w/ no probs. ACPI related stuff works ok. Only when i disabled IRQ for ACPI, w2k werent able to boot properly and after loading (text progress bar) instantly reboot. After enabling ACPI it works again...

Perhaps ur monitor doesnt support so low frequencies (PAL-50Hz)

Maybe something like Norton Speedisk would help ... Deskeeper 5 is damn slow

Maybe something like Norton Speedisk would help ... Deskeeper 5 is damn slow

Get official beta drivers from win2kbox.cjb.net or wait till 3dfx release final drivers

D/l ASPI drivers from Chameleon's site, http://win2kbox.cjb.net/ then upgrade drivers with aspiiinst.exe, reboot and run aspi32.exe, reboot. Run aspichk.exe to check whether aspi drivers are installed correctly. If the picture on the left side has green background everything should be ok If it still telling that aspi driver is up to date, just change date...

Im using Deskeeper 5.03.340 and it works perfect. I didnt have to setup something special to work...

U must have installed ASPI drivers. Go get them on http://win2kbox.cjb.net/

I have BH6 1.0 and can hibernate my puter, (ACPI disabled). Only what wasnt working was ATX shut down. I had to enable APM, since that everything work properly

Yep, i did that and it looks ok NT driver of course doesnt work...i know this modem isnt in HCL, but its correctly detected ;(

I have big problem, i got Microcom Deskporte 56 /W (ESS chipset), W2K fine detects it w/o any probs, but i cantt connect to inet, it opens connecting window, dialing and it hangs and tells me error 777, modem is "out of order" When i start Hyperterminal everything is ok, modem is accepting at commands...