SCSIMANIAC

One question.. Where did you get the drivers? Please email me at beninbrem79@yahoo.com and let me know! Thanks!

Well neither device has SCAM capability...I have assigned the 9.1gig to ID 0 and the 4.5 to ID 1. This isn't an ID problem..that's for sure.. I am trying to find out whether I should use an LVD cable for both devices or whether I can keep my cable and just adjust my settings.. I have the LVD drive set for Single-Ended mode VIA jumper.

Greetings all, I have a Supermicro P6DGS motherboard with onboard Adaptec AIC-7895 Ultra-Wide SCSI. Currently, I have two hard drives, a IBM DDRS39130 Which is a SCSI-2 LVD drive, and an IBM DFHS 4.5 GIG drive. I know that to use the Ultra 2 LVD drive, I need an active terminator, but here is my question, The DDRS39130 is an ULTRA2 LVD drive and the DFHS is not...so how can I run both of these drives on the same chain? I am using a normal Ultra-Wide 3 device cable, and have the jumper set on the DDRS39130 so that it runs in Single-Ended mode...to avoid possible conflicts with the non-LVD IBM DFHS drive. Can someone help me with my configuration...I know there is a problem somewhere..but can't nail it down...appreciate any help.. Thanks!