econ0013

may I possibly get a copy of that document also? Thanks

I am trying to install NT4 iether as single or dual boot (with 95 or 98 - have 'upgrade' NT4) on a 45 GB IBM ATA100 hard drive; I keep getting error/go away messages during setup even though the primary partition is formatted as fat 16 - also it wont let me convert to ntfs during setup. I need to stick with NT4 as I dont have drivers and half my programs dont work in win2K. Any help greatly appreciated. Thanks.

Thanks everyone - replacing the atapi.sys on both the floppies and/or the cd did the trick. I am now happily multibooting OS's again.

It behaves like teh full version ie will do a vanilla install from teh 3 floppies but will also happily install as an upgrade - I usually run a triple boot system 95,NT4 and 2K 9for experimental purpoises only) based on its boot loader and it is quite happy with it with installation in that order.

I am upgrading from 95 but have tried it and can upgrade from 98 but same results. Even using a clean install to the 1GB fat 16 primary (boot) partition using the three setup floppy discs still gives error message. The partitions are as follows 1GB-fat 16 2GB-fat 16 2GB-fat 16 2GB-fat 16 some unpartitioned space (about) 16GB-fat32 (about) 12GB-NTFS Have partition magic6 to redo partitions I can not get far enough to install service packs, get error messages before first reboot during setup. Thanks

My boot partition is 1GB; and it is still giving me these problems

forgot to mention - board is KT7A+R; can I get around it using the raid setup any way?