MINz 0 Posted June 30, 2001 You can install Liveware 3.0 for Windows 2000 on XP. The only catch is you need to replace the DEVLDR32.EXE with the version that comes on your copy of XP (i386/drivers.cab). Expand the cab and find DEVLDR32.EXE and copy it to a temp folder. Then boot XP into safe mode. Run the task manager and click the processes tab to make sure DEVLDR32.EXE isn't running. If it's running end the process. Then you can just copy the XP version of DEVLDR32.EXE to the /WINDOWS/SYSTEM32 folder and replace the Creative Labs version. This fix remedies the system stall you will encounter when trying to shutdown or reboot. All the functions of Liveware will work properly. Hope this helps MINz Share this post Link to post
foofy 0 Posted June 30, 2001 I don't have a devldr32.exe in my driver.cab file. Would you post yours? Also what build are you using, I have 2481. Share this post Link to post
MINz 0 Posted June 30, 2001 I'm using RC1(2405). I've been using XP since build 2428 and I've been replacing my DEVLDR32.EXE file since Beta2(2462). It should be there. If you still can't find it PM me with your email and I'll send it to you. I have DEVLDR32.EXE for build 2481 around here somewhere. MINz Share this post Link to post
MINz 0 Posted July 2, 2001 The solution Mwork provided lets you use the updated Emu10K1M.sys file. This is a much better driver than the old so I say scrap installing Liveware 3 like I previously said and follow the instructions below. To get your SoundBlaster Live to work properly in Windows XP do the following: DRIVER: http://www.soundblaster.com/scripts/down...i/SBL51_W2k.exe NOTE: You can use this driver for any version of the SoundBlaster Live sound card. (Value, MP3, 5.1..ect) Just follow the instructions below. 1) Make sure you are running the SBLive drivers(M$Driver.) that XP installed. If you have already installed previous Liveware software go to Control Panel/Add/Remove programs and remove it. 2) Make new folder on your c: or D: drive and name it "sblive". 3) Put SBL51.EXE, SBL51.W02, SBL51.W03 and SBL51WDM.LIB files in the sblive folder. 4) Go to the Device Manger/Sound, video & game controllers and remove: Creative SB Live! (WDM) & Creative SB Live! Gameport drivers. 5) In a start/run box type - c: or D:\sblive\sbl51.exe /w <---the "/w" switch is very IMPORTANT! 6) When the installation prompts you to replace the RC1 drivers with the unsigned Creative Labs drivers click "STOP". The installation will continue. (Sometimes you aren't prompted to install new drivers but this is not a problem.) 7) When done installing the updated drivers - REBOOT 8) After booting to the desktop screen windows will detect new hardware. When it finishes REBOOT again. 9) Now you have sound! If there is anything I missed or needs cleared up let's get these instructions as complete as possible. MINz Share this post Link to post