Any Hardware install on W2K SP3

[Steve Martz 0]

I have tried to install 2 different nic's (Belkin F5D5000 and a Linksys LNE100TX) and a Cisco PC350 Airnet card in a WIN2K SP3 machine with no luck. Each time I receive a message that the driver data is invalid or not of the expected type. The device then shows in Device Manager under other devices as not configured correctly, Code 1

My system has an ECS K7S5A mb, 512 mb of Kingston PC2100 ddr, running W2K SP3, Leadtek Geoforce 2 MX Video w/32mb and a SB 512 pci sound, AMD 1800XP+(not overclocked) and the bios is currently set to a PnP operating system.

Any help would be appreciated.

Thanks,

Steve

[adamvjackson 0]

Do you get that error with the drivers included with the hardware, and drivers downloaded from the manufacturer's web sites? Did you do a clean os install yet?

[Steve Martz 0]

Adam,

I have gotten the error both ways. The install was new several months ago and I am pretty careful about installing things. I just installed sp3 in the last two weeks but got the error both before and after the service pack install.

I just downloaded and tried to install the latest Belkin driver and it seems to find only the driver in the C:\winnt\inf directory even though I point it towards the C:\belkin directory. I then get a message about Microsoft signed drivers stating that this one is not. Is there an option to only use Microsoft signed drivers that I may have accidentally set?

Thanks,

[adamvjackson 0]

There is such an option, but is sounds like that option is off, which is just fine. I found an article on the MSKB that might be of some help.

 

http://msdn.microsoft.com/library/defaul...eshoot_5e93.asp

 

This basically says to reinstall the driver. Have you tried up[censored] the motherboard drivers yet?