Jump to content
Compatible Support Forums
Sign in to follow this  
elux123

server on lan

Recommended Posts

Hi All

Need your help with a problem, I am running windows XP SP1, and connect to the net using an ADSL modem/router I have a small lan setup with one of the computers running Serv-U ftp server, the problem is that people cannot connect, they can ping to my ip address ok but I suspect that i need to somewhere tell the software or the router how to get the info to the computer running the server software how do I do this??? been trying for the best part of a week now but with little success help!!!

 

thanx Elux123

Share this post


Link to post

You need to forward all port 21 (FTP) requests to the internal machine on your lan using the router.

 

What make is the ADSL modem/router?

Share this post


Link to post

Thanks for replying

 

The router is an eTEC, I can adninister the settings using IE this brings up the conexant page, looked through this but cant find any ref to port settings, I found a page where i can add a route table setting:-

 

Destination Gateway Netmask

 

Tried to set this up to point to the m/c running the server i.e.

 

Destination .... IP address of m/c running server

 

Gateway .... Server assigned IP address

 

Netmask .... Not sure if I should put 255.255.255.0 or the netmask on my LAN

 

so I tried both problem is that I have to flash the router with the new settings and as I dont have a dynamic IP the server assigned IP changes when the router reconnects so the gateway settings I assigned have changed dont know if thats part of the problem.

 

Thanks again .... Elux123

Share this post


Link to post

Hi Elux,

 

Here's a page with all sorts of info about dabs.com's Conexant ADSL router which appears to be the same model as your eTEC box. So it may help you get what your after.

 

http://www.cazart.plus.com/conexant/

 

It might be worth reading through whole page but most of it you can ignore; the important bit is under Configuration - Virtual Server;

 

'Virtual server is how you allow the outside world to initiate connections into your LAN. For example, if you want to run a web server on your PC 10.0.0.12, make public port 80 and private port 80 (or whatever your server use) and the Host IP Address 10.0.0.12. Do this for each port you want to allow hosts on the Internet to access.'

 

Remember that you are only concerned with port 21, you wouldn't want to open any more to the Internet than what's needed.

 

Good luck smile

Share this post


Link to post

Hi ross-aveling

 

Been workin away 4 a few days hence the delay in replying, thanks 4 the info set up the virtual server as u suggested and bingo, works fine now,

many thanks for your help ... elux laugh

Share this post


Link to post

Please sign in to comment

You will be able to leave a comment after signing in



Sign In Now
Sign in to follow this  

×