Abit BP6 - Celeron 400's- 500's

[bigb 0]

How Stable is celeron 400's overclocked to 500mhz or higher on this board,,, has anyone done this? and how was it ,, must know fast ,, would like to buy a few of these setups (or should I).

 

Thanks bigb

[EddiE314 0]

I have an ABit BP6 with two cel400a's overclocked to 500MHz, i did have the up to 550, but i though i'd try to extend their lives. They're very stable as long as you have sufficient cooling.

 

[This message has been edited by EddiE314 (edited 10 February 2000).]

[QAZ 0]

I have a BP6 w/2 366. I run all the time at 500 (5.5 x 91 or 92mhz, don't remember) and have never had a problem. This FSB should allow a 1/3 multiplier on PCI bus so it still runs abit slower then 66mhz spec. I also have a V3-3K, SBLive, IntelEtherPro 100 and 192 mb PC100 ram. When I game, I bump it up to 550 (5.5 x100), which on occasion does crash, but not that often.

 

Good luck and check out www.bp6.com, nice site for BP6 owners.

 

-QAZ

[bigb 0]

How Much Cooling do you think i should put in there to really keep it down (heat) eddie

[bigb 0]

 

[This message has been edited by bigb (edited 10 February 2000).]