Fedore Core3 and SMC 2532 wireless

[Orienell 0]

I am running Fedore Core 3 and a SMC 2532 wireless adapter. It is working but the performance seems to varly greatly. The link quality is always very good but I've noticed that the tx-power is all over the place.

 

wlan0 IEEE 802.11-b ESSID:"tsunami" Nickname:"tsunami"

Mode:Managed Frequency:2.437GHz Access Point: xx:xx

Bit Rate:11Mb/s Tx-Power:2944 dBm

Retry min limit:8 RTS thr:off Fragment thr:off

Encryption key:off

Link Quality=92/92 Signal level=-40 dBm Noise level=-91

Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0

Tx excessive retries:0 Invalid misc:0 Missed beacon:0

 

I tryed setting the power to max but it seems that that feature is not supported in this adapter.

 

[root@b-laptop wlan]# /sbin/iwconfig wlan0 txpower auto

Error for wireless request "Set Tx Power" (8B26) :

SET failed on device wlan0 ; Function not implemented.

 

Has anyone else seen this? Can anyone give me a hint on how to statically crontrol this card?

 

Thanks

Brian

[Xray21 0]

Please...please...please tell me how you got the SMC 2532 to work. Fedora C3 doesn't even recognize my card. Thanks!

[iamroot 0]

I'm not so sure if this will help but i surfed thru the net and found this.

 

http://list.driverguide.com/list/LINUX/company1185/

[Xray21 0]

Thanks, tried that already. On another thread, I think I discovered new in site. It might just be the PCMCIA slot itself. Friend had same cardand same kernel, same flavor, different laptop. Going to try something with pcmcia hardware config. Thanks again!