Jump to content
Compatible Support Forums
Sign in to follow this  
peterro

GeForce and AMD

Recommended Posts

I just got an ASUS V6800 Pure GeForce256, and it seemes to work fine both under Win98SE and Win2000 (Full)

Problem is that i have an AMD 500MHz and a FIC SD11 mainboard. The system doctor under Win98 complains about the AGP voltage sometimes is OK, but sometimes has trouble providing enough power, and says that the system might be unstable. From the little I have had time to test it, it seems to work fine (with an incredible speed, I might add).

 

The thing that I wonder about though i this: will the system just be unstable if the card doesn't get enough power, or could this cause serious damage to my system? I looked at both the FIC and the ASUS homepage, but it doesn't say anything about this. Does anybody know?

 

My full spec is:

AMD Athlon 500MHz

FIC SD11 mainboard

128MB SDRAM

IBM 20,5 GB ULTRA ATA/66

ASUS V6800 Pure

Enlight 300W powersupply

Sony DDU220 DVD-ROM

 

Hope someone can give me a reply quickly!!!

 

------------------

Share this post


Link to post

The Athlon needs a specific power supply capable of providing over 230-250 watts I think, is it an Athlon approved PSU?

 

Ewps - so I was half-asleep and not noticed the sig - I presume Enlights are Athlon approved cos I have one of those myself smile

 

Soz - can't think of anything else.

 

Exorcist

 

[This message has been edited by Exorcist (edited 09 February 2000).]

Share this post


Link to post

It is approved by Athlon. I know how bad things can get if u have problems with the PSU, so I bought a good one.

 

I just wanna know i any of my HW can get damaged by this, 'cause if not, I will run it without any overcloking or other to keep it running, wait a month or two and buy a new motherboard, with higher busclock and stuff.

 

------------------

Share this post


Link to post

I had lots of trouble with win2k and the SD-11, i had 5 devices on 1 irq, which was # 9, my computer crased every 5 minutes with the nvidia beta drivers installed on my CL TNT2 Ultra. i have an enlight 250 watt power supply, athlon ok.

Share this post


Link to post

Please sign in to comment

You will be able to leave a comment after signing in



Sign In Now
Sign in to follow this  

×